ENGLISH
–11–
DELAY START/STOP (TIMER)
The timer buttons enable two separate functions: one to
automatically start the unit within a 24 hour period of time
and another to automatically turn off the unit within a 24 hour
period of time. These functions are called, respectively, AUTO
ON and AUTO OFF.
AUTO ON INSTRUCTIONS:
1.
Press the
TIMER
button twice, or until the TIMER ON
LED on the air conditioner's control panel should illumi-
nate. The air conditioner's display shows the last Auto-On
setting (if any). Now you are ready to reset the Auto-On time
to START the operation.
2.
Press either the
or
buttons to set desired
Auto-On time. Each time you press the
button, the time will increase in 30 minute
increments, up to 10 hours, then in 1 hour increments up to 24 hours.
3. After setting the
TIMER ON
, there will be a one-half second delay before the remote
controller transmits the signal to the air conditioner. Then, after approximately
another 2 seconds, the time setting will disappear from the unit's display and the
set temperature will re-appear on the display window. The Timer ON LED should
remain illuminated.
AUTO OFF INSTRUCTIONS:
1. Press the
TIMER
button once, or until the TIMER OFF LED on the air condition-
er's control panel should illuminate. The air conditioner's display shows the last
Auto-Off setting (if any). Now you are ready to reset the Auto-Off time to START the
operation.
2. Press either the
or
buttons to set desired Auto-Off time. Each time you press
the
button, the time will increase in 30 minute increments, up to 10 hours, then in
1 hour increments up to 24 hours.
3. After setting the
TIMER ON
, there will be a one-half second delay before the remote
controller transmits the signal to the air conditioner. Then, after approximately
another 2 seconds, the time setting will disappear from the unit's display and the
set temperature will re-appear on the display window. The Timer OFF LED should
remain illuminated.
Notes: It is possible to set both and Auto-On and Auto-Off program at the same time. All times that are set are
the time from the moment of setting. So if you were to set a delay of 5 hours to turn on and immediately after
set a delay of 6 hours to turn off, then the unit will operate for a total of 1 hour in 5 hours time from now.
All programs are erased after their time elapses, so they will not repeat again the next day until reprogrammed.
Important: If you use a separate timer to obtain more control (such as turning on and off at a specific time every
day), the unit will remember its previous mode. It may, however, return to energy saver mode by default. If you do
use a timer, be sure that it is a heavy -duty grounded (three-prong) timer that is rated for the appropriate amper-
age.
