2
email: [email protected], Website: www.impcollc.com
Unpacking the Mobile Symphony.
The unit is shipped with the casters
(wheels), grille and the top tray inside the cabinet.
Grille Installation.
Before attempting to use your new Mobile Symphony
cooler you must complete the grille installation.
Attaching the plastic tray.
Remove the side pad frames from the cooler
by lifting them up and out of the cooler cabinet. Locate the parts bag in the
cooler and attach the tray top using the push rivets provided. (Picture 1)
Installing the casters.
Some models ship with the wheels already
attached to the cabinet bottom. If wheels are not attached then locate the
wheels inside of the cooler and attach them to the cabinet bottom using the
bolts included.
Installing the grille.
Refer to the installation instructions in the grille bag.
Installing the drain bushing and standpipe.
Refer to Figure 2 and
install the drain bushing and standpipe through the hole provided in the bottom of
the cooler.
Installing the float valve and adapter.
Refer to Figure 3 and attach the
float to the side leg of the cooler using the hole provided. The garden hose
adapter attaches to the brass inlet fitting on the float valve. (Picture 2). Verify
that the hose washers are properly in place. Position the pump snug to blower
housing to prevent contact with the pads.
Connecting to Water
.
Move the cooler to an area where it can be filled
with water and drained. The cooler should be located on level ground.
Connect to a water supply using a commercial grade garden hose (supplied by
customer) connected to the adapter on the float valve and turn on the water.
Verify water tight connections by visually examining both the float / hose con-
nection and the drain plug. (Picture 2)
CAUTION: Water inlet pressure should be limited to a
maximum of 105 PSI or an inline pressure regulator
should be installed.
Adjusting the water level.
Refer to Figure 3 and set the water height as
shown by adjusting the float.
Connecting to a Power Supply.
Plug the grounded plug directly into a
120 Volt AC 60 Hz grounded GFCI protected electrical power supply.
Note:
Improper voltage will burn out the motor and pump windings and will void the
warranty.
LOCATION
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED
• 3/8˝ Open End Wrench
• 3/8˝ Box End Wrench
• 6˝ Adjustable Wrench
• 7/16˝ Box End Wrench
• #2 Phillips Screwdriver
Picture 1
Picture 2
Picture 3
Figure 2
Figure 3
Figure 4
Figure 4
Always make sure the unit is operated on a level surface. When
using indoors, the best location for it is near a partially opened
window or door where hot outdoor air can be drawn into the
unit. This cooler is portable, but use caution when rolling the
unit to avoid splashing and spilling of water. Cool air can best
be directed through the space by using a partly opened window
or door, ideally one that is situated on the opposite side of the
space from the cooler. This allows the cooled air to be moved
through the space and exhausted back outdoors which is
critical to proper performance of the cooler.
!
Figure 5
Push Rivet
Hose Adapter
Drain Bushing
Washer
Cooler Bottom
Lock Nut
Washer Inside
Cap
Cap
