6
Assembly
Attaching the LEDs
The eight LED strips have magnets that allow you to attach them
to any section of the frame.
• Use the LED strips as key lights by attaching them to the
front-top or front-side rods.
• Use the LED strips as accent or back lights by attaching
them to the back-top or back-side rods.
The booth is designed with eight holes that allow you to pass
the power cords through and attach them to the dimmers. Align
the LED strips so the cord is close to one of the holes.
8
To power the LED strips, connect them to the dimmers, and plug
the dimmers into an outlet.
The dimmer knob turns each LED strip on and off, and controls
the brightness.
Large Diffuser
If you want to use lights other than, or in addition to the LED
strips, fit the large diffuser over the front of the booth to soften
your lights.
Attach the diffuser with the four touch-fastener tabs located
in the corners of the booth’s front opening.
When using the large diffuser, unzip the side panels to shoot
your subject from an angle.
10
Side Flaps
The side flaps can be partially or entirely unzipped for an
unobstructed view or when shooting your subject from a side
angle.
To unzip the side flaps and secure them so they’re out of the
way, follow these steps:
1. Unzip one or both side flaps.
2. Fold or roll the flaps outward so the silver fabric faces out.
3. Use the touch-fastener strips at the top and bottom of the
flaps to secure the folded flap and keep it out of the way as
you shoot.
9
8
9
10