impact EX-100A, Инструкция по эксплуатации

Страница: 18 / 20

Mount on a stand
(1) Select a stand or support
system of suitable weight
and dimensions to ensure
stable operation of the unit.
Install Reflector &
Modeling Lamp
(2) Remove the protective
cap by pressing in and
turning it counter-
clockwise. Pull the cap off
and set aside.
(3) Install the modeling
lamp by screwing it into the
threaded socket.
CAUTION: Do not touch the lamp with your bare hands. Oil residue from your fingers can
cause the surface of the lamp to heat unevenly and explode. Use white cotton gloves or a
clean cloth.
(4) Install the reflector where the protective cap was before. Align the two notches on
the reflector with the white guidelines on the flash unit, press the reflector in and rotate
clockwise until it locks in place. Rotate the outer ring to secure the reflector.
Note: Take care when fitting or removing reflectors or softboxes to not damage the
flashtube assembly. The flashtube is very delicate. Always switch off the unit and
disconnect the power before fitting or changing lamps, flashtubes, reflectors, or softboxes.
Preparing Your Monolight for Use
Page 18 Page 3
10M 25M 50M 75M 100M 10Y 25Y 50Y 75Y 100Y
1
3 4
2
Specifications
EX-100A
Power Output 100 W/S
Guide Number
1
30
Output Control Range Full power to 1/8 stepless
Recycling Time 1~2 seconds
Flash Duration 1/1000 ~ 1/1500 second
Flash Ready Indicator LED and audible beep
Modeling Lamp 60W (not to exceed 100W)
Triggers Sync cable, slave sensor, test button
Trigger Voltage 4.3V
Built-in Slave Cell Yes
Color Temperature 5800°K ±200°K
Flash Tube Plug-in type, user replaceable
Reflector Mount Elinchrom-type
Sync Cable 1/8˝ phono jack
Power Source 110~120V AC, 60Hz
Circuit Protection 6.3A Fuse
Dimensions 9.5 × 7.75 × 5˝ (240 × 198 × 127 mm) – without reflector
11.25 × 8.25 × 10.3˝ (285 × 210 × 262 mm) – with reflector
Weight 2.6 lb. (1.2 kg)
1
Guide Number is calculated at f/8, 10ft, ISO 100, using the included reflector, and is a starting point.
You should perform your own evaluations to determine the results you prefer.
Contents of carton
Carefully remove the monolight from the box. You should have the following:
• monolight with protective cap and flashtube installed
• 60W modeling lamp
• 8˝ grid reflector • sync cable
• spare fuse • power cable • user manual
You may also have other items, such as a light stand, umbrella, or softbox,
if you purchased the EX-100A as part of a kit.