MH630 240V / MH631 110V Vibrating Hammer
MH630
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and unplugged before carrying out any work on the tool.
Side handle (auxiliary handle)
For tool with stick type side handle
1.
Side grip (auxiliary handle)
The side grip swings around to either side, allowing easy handling of the tool in any position. Loosen the
side grip by turning it counterclockwise, swing it to the desired position and then tighten it by turning
clockwise.
Installing or removing the bit
1.
Bit shank
2.
Bit grease
Clean the bit shank and apply bit grease before installing the bit.
Insert the bit into the tool. Turn the bit and push it in until it engages.
1.
Releasing cover
If the bit cannot be pushed in, remove the bit.
Pull the releasing cover down a couple of times.
Then insert the bit again. Turn the bit and push it in until it engages.
After installing, always make sure that the bit is securely held in place by trying
to pull it out.
To remove the bit, pull the releasing cover down all the way and pull the bit out.
1.
Releasing cover
1
1
2
1
1
