IMO Jaguar VXM, Инструкция по эксплуатации

Страница: 123 / 168

5-67 5 Function Selection
This function becomes effective, when the
torque limit (braking) is used. The inverter
automatically increases the output frequency
so that torque calculations do not exceed the
braking torque limit setting ( F41 or E17).
(When F41 or E17 is set to 999, it becomes
invalid.)
This function sets the increment of upper limit
for output frequency.
When regeneration avoidance is selected, the
resurrection ability can be improved by raising
the increment of upper limit. However, the
output frequency of the inverter is limited at
the frequency limit (high):F15
Setting range : 0 to 65535
The set value "15" becomes 1Hz.
(The set value "1" becomes 1/15Hz)
When "2" is set in the function code: H07,
both curvilinear acceleration and deceleration
ranges of S-shape can be set up arbitrarily.
The range is the ratio for maximum output
frequency 1 (F03) or 2 (A01).
Setting range : 1 to 50%
100% value of this function means maximum
frequency
(fmax) .
Acceleration time " tacc " and deceleration time
"tdec" of upper figure become longer than the
linear acceleration time and deceleration time.
When the set acceleration time (F07, E10, E12,
E14) is assumed to be "
Ta " and deceleration
time (F08, E11, E13, E15) is assumed to be
"
Td ", "tacc" and " tdec " can be calculated by the
following expressions.
U01 Maximum compensation frequency
during braking torque limit
U functions are displayed from keypad
ROM version K08000 or later
U 0 1 U S E R 0 1
U02 1st S-shape level at acceleration (start)
U03 2nd S-shape level at acceleration (stop)
U04 1st S-shape level at acceleration (start)
U05 2nd S-shape level at acceleration (stop)
U 0 2 U S E R 0 2
U 0 3 U S E R 0 3
U 0 4 U S E R 0 4
U 0 5 U S E R 0 5
At acceleration,
5
119