IMO *G3D-187, Инструкция по эксплуатации

Страница: 7 / 36

7
Imo sales and service representatives are listed herein and in General Instruction Manual, CA-1.
F. OPERATION
F.1 LIQUID LIMITATIONS
Never operate with thin liquids such as solvents or water. Pump is designed for liquids having
general characteristics of oil.
F.2 OPERATING LIMITS
CAUTION ATTENTION
Operating conditions, such as speed, fluid viscosity, temperature, inlet pressure,
discharge pressure, filtration, duty cycle, drive type, mounting, etc., are
interrelated. Due to these variable conditions, specific application limits may be
different from operational limitations. Equipment must not be operated without
verifying system operating requirements are within pump’s capabilities.
Under no circumstances are the following structural limitations to be exceeded.
MAXIMUM SPEED: RPM
ROTOR SIZE
DISTILLATE OILS LUBE AND SEAL OILS RESIDUAL CRUDE OILS
TYPE B & H TYPE B & H TYPE F TYPE B & H TYPE F
187
218
250
312 4400
3600
3600
2500 4400
3600
3600
2500
3000
2500
2150
1800
All Sizes
1800
All Sizes
Consult factory for allowable speeds for alternate seal arrangements.
VISCOSITY: .............. 33 SSU Minimum - Mechanical Seal Pumps
100 SSU Minimum - Packing Pumps
3000 SSU Maximum - Type B Mechanical Seal Pumps
Consult factory for allowable operating viscosity for other seal types at specific speeds
and pressures.
Do not alter design viscosity without prior approval from factory.
TEMPERATURE: ...... Type B: 0-160°F,
Type H: 0-250°F at 1800 RPM or less, 0-225°F above 1800 RPM,
Type F:0-250°F
Consult factory for allowable temperatures for alternate seal arrangements.
INLET PRESSURE: .. Types B and H - 75 PSIG nominal maximum
Type F - 10 PSIG nominal maximum
Consult factory for minimum required inlet pressure.
Special modifications for up to 250 PSIG.
DRIVE: ...................... Direct, belt or chain (Type F - direct only)
FILTRATION: ............ Light fluids - 60 mesh
Heavy fluids - 1/8 to 3/16-inch
MOUNTING: ............. Foot or flange mounted in any attitude