immerSUN automatic power controller, Инструкция по установке и эксплуатации

Страница: 17 / 44

17
What's in the Pack
●
immerSUN
●
Sensor Clamp
●
Fixing Kit
●
Antenna
Locating the immerSUN
Often, the most suitable location for the immerSUN is near to the distribution board as
all the connections required are usually available here.
Alternatively the unit can be mounted next to the load. Note that the
Sensor clamp must
be clamped around the supply meter-tail. There is the option of using the Wireless
Sensor to simplify the installation if required.
The following should be considered when deciding upon the most suitable location:
●
Close to the main incoming mains electrical supply of the property – otherwise
the Sensor Clamp will need to be extended, or the Wireless Sensor option used.
●
Access to heater supply cable (this is usually at the consumer unit)
●
Access to suitable supply via
16A MCB or 13A fused outlet
●
User access to the buttons and visibility of LCD screen
●
Adequate ventilation – keep vents clear and provide airflow around the unit.
Mimi mum clearance top and bottom is 50mm although more is recommend for
ease of access to case screws.
●
Cable access point – through the top, bottom or rear of the unit - the bottom
panel is removable
to give better access when wiring.
Voltage Optimisers
If there is a voltage optimiser installed at the property, care will need to be taken when
positioning and wiring the immerSUN. The Sensor Clamp and the immerSUN will need to
'see' the same voltage, whether this is the optimised voltage or the non-optimised
voltage.
Check the manufacturers instructions before connecting the immerSUN to an optimised
circuit – some optimisers should not be connected to heaters.
Three-Phase Systems
The immerSUN and the Sensor Clamp must be on the SAME PHASE.
If the generation is 3-phase, an immerSUN can be used on each phase, if only one or two
immerSUN's are used, only one-third or two-thirds of the surplus power will be able to be
utilised. The loads will need to be single phase.