BPGS10H PNEUMATIC GRIPPER SYSTEM
User Manual
BIM-BPGS10H-0719 Rev 1 | For Technical Assistance: 800-442-4622
6
JAW REPLACEMENT
1. For lower jaws (10151, 11102 and 11103):
Apply high-temperature grease to cam and inside of jaw. Angle new
jaw so that tail of jaw goes in the pocket of frame. Align pivot hole with boss and drive pin with the bottom side
of the cam slot. Carefully slide jaw over boss and onto gripper. Replace bushing over pin and into cam. Apply
high temperature grease to outside of jaw.
2. Refer to "Installing a Side Plate" section.
3.
Flip gripper over for top jaw installation.
5.
For lower jaws (11103 and 10151):
Remove bushing from lower jaw using a small flat screwdriver or hex key
and set aside for re-assembly. Lower jaw should be rotated completely down before removal. Lift up on front
of jaw by pad so there is an angle between the jaw and frame. Remove lower jaw from gripper.
6.
For lower jaws (11102): Remove lower jaw from gripper.
