Imetec Silk'n Flash&Go Fast I6706, Руководство по эксплуатации

Страница: 42 / 63

EN
77
EN
76
• The subsequent maintenance sessions can be performed from time to
time, when and if necessary, until long-lasting results are achieved.
Note:
The hair removal results will not be enhanced if the same part of the
body is treated more often than recommended (every two weeks).
Dormant hair follicles can be reactivated due to hormonal and physiological
changes. Therefore, occasional hair removal sessions may be required.
The individual reaction depends on the type of hair and biological factors that
may affect the growth cycle of hair. Some people can react quicker or slower
with regards to the recommended hair removal plan.
In any case, a long-lasting result cannot be expected with only one or two
sessions.
NOTE
The appliance is not effective on very light hair.
The appliance is not effective on natural white, grey, light blonde and red hair.
If your body hair is either of these colours, the appliance will not be effective.
INFORMATION BEFORE USE
pOWER LEVEL
The appliance can be set to 5 power levels; 1 (lowest) to 5 (highest), indicated
by 3 power level LEDs (13).
SETTING THE pOWER LEVEL
Press the power level setting buttons (+/-) (9):
“+” to increase the power level.
“-” to decrease the power level.
The power level LEDs (13) light up as follows according to the set power level:
Level 1 (lowest) - the left LED remains constantly on.
Level 2 - the left LED remains constantly on and the middle LED flashes.
Level 3 - the left LED and the middle LED remain constantly on.
Level 4 - the left LED and middle LED remain constantly on and the right LED
flashes.
Level 5 (highest) - all three LEDs remain constantly on.
ATTENTION
It is recommended to always start the first hair removal session by setting
the lowest power level (level 1).
If you feel no discomfort during the hair removal session with the power
level set to the lowest, you can increase the power to level 2 at the next
session, and so on for each subsequent session.
Do not increase the power level if you feel an abnormal discomfort during
or after the treatment! (See “Possible side effects”).
Do not increase the power level during a hair removal session, even if no
discomfort is felt: side effects can also arise some time after the session.
SKIN COLOUR SENSOR (6B)
Using the pulsed light epilation system on dark skin can cause adverse effects
such as burns, blisters and changes in the colour of the skin (hyper or hypo-
pigmentation).
The appliance has a skin colour sensor (6B) that measures the tone of the