GB
Filling the reservoir while ironing
!"
When the water in the reservoir is less than the minimum level, the no water LED (7)
lights up and the iron does not produce any steam.
!"
Lift the reservoir water fill cover (1) and fill the water reservoir (2) without overflowing.
Once finished, lower the water fill cover (1) completely.
!"
The appliance can then ready to continue ironing.
MAINTENANCE
Cleaning the boiler
The boiler must be cleaned when the boiler cleaning LED (6) lights up or every 3 months, in
order to prevent limescale from forming.
The boiler cleaning LED (6) lights up when the boiler must be cleaned. The LED then
remains on and you can start ironing. The boiler cleaning LED (6) will remain on until the
boiler is cleaned.
ATTENTION!
The boiler must only be cleaned when it is cold.
NOTE:
"!
Failure to carry out this operation will make the warranty null and void.
Sequence of operations:
!"
Press the ON/OFF button (13).
!"
Disconnect the plug (14) from the socket.
!"
Let the boiler cool down for at least 4 hours.
!"
Place the boiler on a wash basin.
!"
Shake the base to help the limescale chips detach (Fig. B).
!"
Remove the cap cover (11) on the rear side of the boiler by turning it anti-clockwise
(Fig. C).
!"
Loosen the cleaning cap (12) by turning it anti-clockwise with a coin (Fig. D).
!"
Let the water and lime scale drain from the hole.
!"
Shake the boiler once again for the remaining water and limescale chips to come out.
!"
Tighten the cleaning cap (12) by turning it clockwise with a coin.
!"
Set the cap cover in place (11) by turning it clockwise.
!"
Refill the water reservoir (2) before using the boiler again.
Make sure the cleaning cap (12) is tightened well.
Do not clean the boiler with detergents, anti limescale products, vinegar
or any other type of substance.
Cleaning the appliance:
Before cleaning the appliance, switch it off by pressing the ON-OFF button (13) and
disconnect the plug (14) from the socket. If necessary, clean the appliance with a damp
cloth. Do not use solvents or other aggressive or abrasive detergents. Otherwise, the
surface could be damaged. Before re-using the appliance, make sure that all wet-cleaned
parts are completely dry.
14