GB
PROBLEMS AND SOLUTIONS
This chapter describes the most common problems related to appliance use. If the problems
cannot be resolved with the information below, please contact the Authorised Assistance
Centre.
17
Problem
Possible cause
Solution
The plate (9)
remains cold or
does not heat up.
There is no power supply.
Verify whether the plug (11) is inserted
correctly or try inserting it in another
socket.
Verify whether the temperature
adjustment knob (2) is set to the
minimum temperature
Ø
(Fig. D).
The plate
temperature LED
ƺʸƻ½Å»ÉÅķĺÅŮƔ
Normal procedure.
This indicates the heating phase of the
iron.
¾»ƺʸƻ½Å»ÉÅŮÅĹ»Ê¾»É»Ê
temperature is reached.
Only a little steam
or none at all is
dispensed.
The steam selector (5) is
set to Ø.
Set the steam selector (5) to the
º»É¿È»ºŰ»Âºƺ ¿½ƔƻƔ
There is not enough water
in the reservoir (10).
Fill the reservoir (10).
The impurities that
come out from the
steam holes stain
the garments.
Chemical additives,
scented liquids or
descaling agents are being
used.
These damage the product: do not add
additives to the water in the reservoir.
Pure distilled water or
softened water is being
used.
Mix tap water (50%) with distilled and/
or demineralised (50%) water.
Starch is being used.
Always spray the starch on the reverse
side of the fabric.
Water leaks from
the plate (9).
The plate temperature
is too cold due to the
Super-steam button being
pressed too often (4).
Allow slightly longer intervals between
the jets of steam.
The temperature
adjustment knob (2) is set
to a temperature that is too
low (Fig. D).
Turn the temperature adjustment knob
(2) to the Max level (Fig. D).
MI001087.indd 8
26/01/13 12.23