out of the power socket.
• put the mini-vacuum (8) back on the body of the stick vacuum and press the handle of
the mini-vacuum until the click tells you that it is correctly in place [Fig. d1].
• wind the cable (4) round the two hooks (2a and 2B) [FiG. c1]. with the clamp on the
plug, it is possible to secure it to the cable.
MAINTENANCE
ATTENTION! Turn the appliance off and take the plug out of the power
socket before opening the dust collection system!
Make sure all cleaned parts are completely dry before reusing the
appliance.
CLEANING THE APPLIANCE
When necessary, clean the appliance with a damp cloth.
ATTENTION!
DO NOT USE SOLVENTS OR OTHER AGGRESSIVE OR ABRASIVE
DETERGENTS. THIS CAN DAMAGE THE SURFACE.
CLEANINg THE MULTI-SURFACE BRUSH (7)
With the motor ON, rub the lower part of the brush with your hand to remove the dust and
fluff, which will be drawn.
CLEANING THE DUST COLLECTION SYSTEM (8)
ATTENTION! Empty the dust collection compartment (8B) and clean the
filtering system (8C, 8D, 8E) after every use.
• clean the dust collection system following the instructions below and paying attention
to the figures in the illustrative guide.
• detach the mini-vacuum (8) from the body of the stick by pressing the release buttons
(5) [Fig. d1].
• press the release button (8a) [Fig. e1] and take down the dust container (8B+8c+8D)
[Fig. e2].
• take out filtering system 8c and 8d [Fig. e3] and empty out the contents of the dust
container (8B).
• separate the filter protection mesh (8c) from the cyclone filter (8d), and clean them
by carefully shaking and brushing away the dust. to do so, use a soft brush to prevent
any damage.
• take out the motor filter (8e) and clean it.
• if necessary, rinse the parts of the dust collection system under running water. Before
putting them back in place, make sure they are completely dry.
EN
12