Imetec Bellissima Flash&Go Plus 120.000, Руководство по эксплуатации

Страница: 39 / 63

EN
71
EN
70
“Information before use” for instructions regarding the patch test.
DURING TREATMENT
Do not treat the same section of skin more than once per hair
removal session!
Do not overlap the pulses!
• STOP USING THE APPLIANCE IMMEDIATELY if blisters form or the
skin burns.
• Always make sure that the treatment surface (5A or 15A) is pointed
towards the skin and is entirely in contact with it.
• Remove the treatment surface (5A or 15A) from the skin if either (5A or
15A) becomes excessively hot.
AFTER TREATMENT
Do not expose the skin to the sun and/or tanning beds after
treatment.
In case of exposure to the sun during the two weeks following a treatment
session, protect the treated skin with sun cream SPF 30 or higher.
ATTENTION: treatment may cause a temporary change in pigmentation
(refer to “Possible side effects”).
POSSIBLE SIDE EFFECTS
Side effects and complications associated with the appliance are rare when
used according to the instructions.
However, any cosmetic procedure, including those intended for home use,
pose a potential risk. It is therefore important to understand and acknowledge
the risks and complications that may occur when using pulsed light epilation
systems designed for home use.
Negative
Event
probability of the
Negative Event
Negative Effect
probability of the
Negative Effect
Accumulated
multiple pulses
or overlapping
on the same
section of skin.
Minimum
Minimal Discomfort to the Skin Minimum
Redness on the Skin Minimum
Greater Skin Sensitivity Minimum
Wounds and burns Rare
Scars Rare
Changes in Pigmentation Rare
Excessive Swelling and
Redness
Rare
Infection Negligible
Bruising Negligible