IMET KS 450 FT, Инструкция пользователя

Страница: 7 / 53

TRADUCTION OF THE ORIGINAL USER’S INSTRUCTIONS
KS450FTeng ED.2011 rev.34 7
6 - TECHNICAL CHARACTERISTICS
Hydraulically driven semiautomatic bandsaw. Suited for cutting metal profiles and solids from 60° left to 60° right. In
compliance with CEE Safety Standards and Electromagnetic Compatibility Norms (EMC). Steel sawframe with tubular
section; worktable supported by preloaded central bearing. Automatic stops at the positions 45° left, 45° right and 0°.
Adjustable taper rollers located on the rocking pin. 360mm pulleys, Long Life reducer. Blade-driving guides with hard
metal pads and driving bearings. Equipped with a new compact base and a worktable with presetted passages for
the blade line on most used angles. Easy positioning of the vice, with fully hydraulic stroke on 450 mm, along the
woktable width, with manual clamping.
STANDARD VERSION COMPLETE WITH:
-electric equipment complying with E.C. Norms EN60204-1, EN-55011, EN-50082-2, 2 speed three-phase motor ;
-general switch which can be locked, minimum tension coil, thermo-magnetic overloads motor protection, emergency
button, warning light for low tension 24V, for blade tensioning, for blade cover and motor overload.
-cutting cycle: AUTOMATIC fast approach of the sawframe to the cut-start point, then the machine adopts the cutting
speed until reaching the cut-end point, which is checked by a microswitch; as a final step, the sawframe goes back to
the cut-start position and the blade stops.
-hydraulic regulators for feed speed and feed force, located on control consol
-mechanical blade tensioning up to 1700 kg/cm
2
, microswitch for checking the tension, instant stop in case the blade
breaks or is not tensioned -hydraulic front vice free to move transversally on the worktable, ; hydraulic vice opening
460 mm, jaws height 180 mm
-blade-cleaning device by means of a motorized brush
-floor stand equipped with removable chips collector and apt to be moved with forklift; hydraulic unit with oil; tank and
electric pump for coolant; bi-metal band.
-wrenches and manual of instructions, maintenance and spare parts.
VARIATIONS BE MENTIONED WHEN ORDERING THE MACHINE
Blade size 34 x 1,1x 4250 mm by a longer saw frame structure.
Electronic Speed Control –ESC- which grants a continuous blade speed variation by an inverter on the motor.
If not differently indicated, all data reported in this manual refer to the standard version, suitable for working at
400 V / 50 Hz THREEPHASE.
= cutting capacity ( max. dimensions on PROFILES & TUBES)
= BLADE DIMENSIONS = WEIGHT =VICE OPENING
= motor choice and blade speeds (at 50 Hz);
Dimensions
( cm )
B L H
mm Kw Mt/min mm Kg
In use 140 225 218
ON REQUEST
4250X27X0,9
1,7 - 2,2
3~
35 and
70 460 830 net
825 gross packed 140 245 180
ON REQUEST
4250x27x0,9 ESC - 2,2
3~
from 15
to 100 460 835 net
830 gross
4250X34X1,1
1,7 - 2,2
3~
35 and
70 460 860 net
855 gross
4250x34x1,1 ESC - 2,2
3~
from 15
to 100 460 865 net
860 gross
WORKTABLE MIN. HEIGHT = 850 mm