IMER
U.S.A. Inc.
- 9 -
WORKMAN 350 II MULTIMIXER
NOTE
It is very important to keep the engine pulley and the
drive pulley in line with one another. Failure to
maintain this alignment will cause the belt to twist and
then break.
Wheel Bearings
1. The wheel bearings should be cleaned and repacked every 6 months to 1 year. The interval being
dependant upon the amount of time the machine is towed, and under what conditions. This
maintenance procedure is the same as that for automotive wheel bearings.
Engine
Read the Honda manual carefully ... and follow their instructions.
Changing the oil and cleaning the air filter frequently ensure a reliable and long lasting motor.
When you may need Honda Engine Service or Warranty Assistance, take the machine to your local Honda
power equipment dealer, they will honor the warranty throughout America.
NOTE
It is always a good idea to check the oil level in the
engine crankcase at the start of each working day.
Clean oil at the correct level makes for a engine that
will last and last.
Mixer’s drum disassembly and re-assembly
In case it’s necessary to remove the drum, to reset it it’s necessary.
- to clean carefully the gear shaft cone and the drum cone.
- to place the drum on the shaft cone, making sure that shaft shear pin is inside its seat in the drum cone.
- to block drum tighting screw with washer by following tighting torques:
Workman 350 II: 300 ± 20 Nm.
MISC.
Every month check all the mixer's mounting hardware to
ensure all the nuts and bolts are properly tightened.
