ITalks MCS 1608 V2
Installation manual click version
Installation manual Click version 02-04-2020 Page 1 of 3
Contents (see image 1):
1x ITalks MCS 1608 V2, packed in an antistatic bag and stickers with the DEVEUI number and SIGFOX ID
1x small bag of Silica gel (do not open).
1x Batterypack (blue or black)
1x Enclosure (1 cover, 1 bottom and 1 click mounting plate)
1x Rubber seal (pre-mounted on the cover, only on non-vented covers)
There are different versions of the cover (Click Small, Click Large, Click Vented), all three are mounted the same
way, the only difference is that de vented cover does not need a rubber seal.
Assembly instructions:
1.
Open the antistatic bag and put the DEVEUI/SIGFOX stickers on the enclosure where it is legible.
2.
Connect the battery as pictured (Image 2).
Note: please do this carefully and in the correct connector (J1).
Check:
you will see a LED blink.
3.
Put the ITalks MCS 1608 V2 together with the battery pack in the
enclosure.
Be sure the battery connector is facing up and towards the lid.
The PCB will fit into the two slits on the inside of the enclosure.
Check:
on the top of the enclosure you will see the LED blink.
Image 2
ITalks MCS
1608 V2
Image 3
Image 1
www.ime.de
ime mobile solutions GmbH • Borsigstraße 7-9 • D-93092 Barbing • +49 9401 9333-0 • [email protected] • www.ime.de
25-05-20
