12
To search the interfaces connected in local area network (LAN not in
Internet WAN), you must click on the "Search" button.
After a few seconds of work, the program will report all of the devices
found in the network showing the type, firmware version, the MAC address
and IP address of the card or interface.
Knowing the IP address, the user can access through a standard browser
to change the required parameters.
The key pad “Reboot” has no effect on the IF4E011. It is primarily used on
IF2E011. The key pad “Restore” forces the interface to operate with
default factory parameters.
Firmware update
For this, contact your commercial representative or technical IME support.
How to use TFTP program
For this, contact your commercial representative or technical IME support.
Service and special Function
For this, contact your commercial representative or technical IME support.
Led Power and reset button
For this, contact your commercial representative or technical IME support.
Factory Settings
The interface is provided by the IME spa fully tested and functional. To this
end, the interface is configured and tested with the factory parameters
published in this small Legend:
Working Mode:
Bridge
LAN Section
IP:
192.168.1.100
Mask:
255.255.255.0
Gateway:
none
DHCP:
none
RS-485 Line
Baud rate:
9600
Parity:
none
TimeOut:
100 ms
Bridge Section
Protocol:
RAW Data
Port:
502
TimeOut:
10 s
Mail server
IP:
62.212.12.161
Porta:
4080
IP Setting
RFC_1968
Enabled
(only LAN address)
