IMC MISTRAL 13 Series, Инструкция по установке и эксплуатации

Страница: 8 / 25

Mistral M60, M90, M135
8
INSTALLATION
For the Installer
These Instructions contain important information designed to help the user
obtain the maximum benefit from their investment in an IMC Mistral Bottle
Cooler.
Please read them carefully before starting work, and consult with the supplier in
the event of any queries.
Be sure to leave this Instruction Manual with the user after installation of the
machine is complete.
Procedure
WARNING
The following table shows the weight and the minimum quantity of
people required to lift each unit:
Bottle Cooler Net Weight
Quantity of
People
M60 (all variants) 57.5 kg (max) 2
M90 (all variants) 76.5 kg (max) 4
M135 (all variants) 125 kg (max) 4
Install the unit on a flat and level floor.
Ensure a min 10mm clearance either side of the unit, there is to be a min
20mm clearance at the top of the unit and a min 60mm clearance at the
back.
The M135 is supplied on castors to aid installation and cleaning.
Do not install the unit close to a heat source such as a radiator or a warm air
outlet. Ensure that the unit is standing level by adjusting the feet on the base of
the unit.
The unit has an automatic defrost cycle and evaporates all the condensate
water without the need for a drainage system.
NOTE!
The castors on the M135 are to aid installation only. The
machine is not designed to be used as a mobile unit.
It is important to install the Bottle Cooler on a flat surface. This
ensures that the doors are level. Adjustment is provided via the
feet, to enable the installer to level the cabinet.
Engineer Call-outs in order to level Bottle Coolers, will not be
covered under warranty.