IMC IMPACTOR IP700, Инструкция по установке, эксплуатации и обслуживанию

Страница: 6 / 13

4 IP700
PREPARATION
Strip off the protective vinyl covering from the stainless steel sheeting. If appearance is not
an important factor it does no harm to leave this protection in place.
SITING AND INSTALLATION
For the installer:
These instructions contain important information designed to help the user obtain the
maximum benefit from the investment in an IMC Waste Compactor.
Please read them carefully before starting work, and consult with the supplier in the event
of any queries.
Please leave this Instruction Manual with the user after installation.
Procedure:
The Compactor is designed to reduce the volume of rubbish. The maximum advantage is
gained if compaction is carried out at the point at which the waste arises. This results in
minimum movement, reduced handling, and maximum cost savings. Alternatively, it is
possible to order extra trucks for larger establishments or waste segregation.
Ensure that the Compactor is located on a flat and level floor. Ensure that
sufficient additional space is available to allow the truck to be withdrawn. The front
pair of castors are fitted with brakes, which can be locked into position by
depressing the pedal. Push truck into machine, and ensure it is latched in.
PREPARING FOR USE
·
Lower the floor plate by loosening the six
bolts (three each side) fitted to the side of the
lower frame angles. Lower the floor plate into
position and tighten the six bolts to fix the
floor plate into place.
NOTE Holes on the bottom of the floor plate
are for fixing the unit to the floor. See diagram
for fixing hole dimensions.
·
Ensure that the wheelie bin lid is in an open
position before placing the bin into the unit.
·
The compactor will not operate unless the
wheelie is properly in position and the door
closed.