MOBILE HAND WASH UNIT 5
Commissioning
Remove the front panel by unscrewing the black knob on the front of the unit, tilt
the panel backwards and pull upwards away from the unit at an upward angle.
This will enable the operator to gain access to the clean and waste water
containers inside the unit.
Once the front panel has been removed, lift out the suction hose from the clean
water container and remove the water container. Note the water container can
hold a maximum of 20 litres. You can fill the container with less if you want.
Ensure when refitting the water container that the suction hose has been placed
at the bottom container. Check that the funnel is fitted to the waste container and
position under the sink waste pipe.
We advise that you operate the foot pump and pass water through the unit before
refitting the front panel. To prime the pump depress the foot pump several times
until water is seen coming out of the spout located above the sink on the unit.
Once all of the above steps have completed and the front panel has been refitted,
your Mobile Hand Wash Unit should now be ready for operation.
