31
Unit FiberAlert –
Enables/disables FiberAlert and LinkLoss functionality on the unit.
The settings include:
•
No FiberAlert Or LinkLoss Enabled
•
FXLinkLoss Only, Enabled
•
TXLinkLoss Only, Enabled
•
FiberAlert Plus FXLinkLoss Enabled
•
FiberAlert Plus TXLinkLoss Enabled
•
TXLinkLoss Plus FXLinkLoss Enabled
•
TXLi FXLi FiberAlert Enabled
•
FiberAlert Only
NOTE
FiberAlert is not offered on the all-copper (RJ-45) version of the iMcV-Giga-FiberLinX-II.
Unit LoopBack –
Enables/disables Loopback functionality on the unit. The settings
include the following:
•
No LoopBack, Normal Traffic Mode
•
LoopBack Enabled
•
LoopBack, Src/Dest Address Swap
•
LoopBack, Address Swap, Clear Multicast bit
•
No Learning on OPTICS (or UPLINK) or DATA Ports
Unit Max FrameSz
– Enter the maximum frame size on the unit by using the number
keys.
•
No VLAN–1518
•
VLAN Tag–1522
•
Oversized frames–1536
•
Oversized frames–1916
802.1p Base Pri
– Set the threshold between low and high priority on the unit. For
example, when the Base VLAN Priority is set to 4, priority settings of 0 through 3 are
low priority and settings of 4 through 7 are high priority. When the Base VLAN
Priority is set to 3, priority settings of 0 through 2 are low priority and priority settings
of 3 through 7 are high priority.
BrdCast Max Rate –
Set the Broadcast Storm protection. Valid values are 0-20%
where 0% disables Broadcast Storm protection. The setting is the percentage of line
speed where broadcast frames will be dropped. For example, if the setting is 1% and
the unit detects that broadcast traffic is exceeding 1% of the line speed then the unit
will discard broadcast frames. The suggested setting is 1%.
