20
This function enables all of the device traps. Use iConfig to configure the device to
selectively activate and de-activate traps.
Supported traps include: Link Down, Link Up, Cold Start, Warm Start, Last Gasp, and
Authentication Failure.
When deployed in pairs, iMcV-Giga-FiberLinX-II also supports the following traps:
•
Remote Unit Lost
•
Remote Unit Found
•
Far End TX Link Up
•
Far End TX Link Down
•
Remote Unit Cold Start
•
Remote Unit Warm Start
Removing All SNMP Trap Destinations
To remove all trap destinations, press
K
. Press
Y
to continue when prompted and
remove all trap destinations, or press
N
to abort. Press
Enter
to finish.
This function will delete all trap destinations. To selectively delete trap destinations
or select the type of trap reported or not reported, use iConfig to configure the
device.
Creating SNMP Community Strings
The default community string is named public and has read/write access. It is
recommended that custom community strings are created (with read-only access for
general use and another with read/write access for the administrator) and tested
before deleting Public. To create a new community string, go to the main
configuration screen and press
C
. Enter the name of the new community (up to 16
characters, no spaces) and press
Enter
. Then type one of the following to assign the
community string’s access rights:
•
R = read-only access
•
W = read/write access
•
Enter = abort
Deleting All SNMP Community Strings
To delete all community strings and start over, press
U
. Press
Y
when prompted to
proceed and delete all community strings,
N
to abort. Press
Enter
to finish.
This function will delete all community strings. To selectively delete community
strings, use iConfig to configure the device.
Ending The Session
Press
E
to end the session before disconnecting the serial cable. This will stop the
continuous stream of data that is sent to the serial port.
