13
9、COMMON PROBLEMS AND SOLUTIONS
Fault phenomenon
Cause analysis
Solutions
The cut
interlining has
silk adhesion
besides the notch
1. The moving knife
is not installed
properly；
2. Normal working
wear。
Cause 1 adjust the feed rate of the moving
knife according to the operation steps in
6.1.
Cause 2 replace the moving knife and solid
knife according to step 6.2.
Stitched lining
not centered
1. Device position
movement；
2. Bartack length
adjustment。
Adjust the guide mechanism: 050200913002
embossing hand wheel controls the left
and right directions, two 050200904003
plum handle screws control the front and
rear directions, and the specific
adjustment direction is adjusted
according to the actual direction of the
lining deviation.
