iMartine Vrillo J300, Руководство пользователя

Страница: 6 / 18

Product Introduction Installation
Installation
5. Starting up and charging
。
Long press to switch on the robot. Charge the robot on charging
base when the power indictor light is normally on.
Note: If the machine cannot be started due to low battery,
please charge the host on the charging base and the machine
will be started automatically. The machine can work normally
only when the battery level is ≥ 20%.
6. Connect with the Near APP
(this step can be
skipped)
Please refer to Wi-Fi connection guideline, then connect mobile
APP.
7. Start cleaning
After the robot is powered on, short press key on the robot
or use mobile APP to start cleaning. (press any button to
pause during using).
Note:
• The sweeping robot cannot be used to remove liquids.
• If the battery level is less than 20, the machine cannot work.
Please charge it.
• The machine will return to the charging base automatically if
the battery level is less than 20% in use and will be powered off
and start cleaning automatically after the battery level reaches
80%.
• Please clear various wires (including power line of charging base)
on the ground before use to avoid outage and damage of
objects or wires when wires are dragged by the host.
8. Installation of mopping module
①
Installation of mopping cloth: paste the mopping cloth flatly to
the bottom of water tank.
(Hanging permeate type water tank)
(Electric-controlled water tank)
(2 in 1 electric-controlled water tank)
Note: please clean the mopping cloth after using to keep it in
good cleaning condition.
②
Fill the water tank: uncap the cover and fill with water
(Hanging permeate type water tank)
(Electric-controlled water tank)
(2 in 1 electric-controlled water tank)
please take out the dustbin by handle before fill with water
③
Install the module: push the module horizontally along
the rear part of the robot. The module is installed in place if
you hear a "click" sound.
(Hanging permeate type water tank)
(Electric-controlled water tank)