
SELENIO™ SEL‐1DEC1/SEL‐1DEC2
Installation and Operation Manual
Removing Selenio Modules from an MCP3 Frame
© 2014 Imagine Communications Corp. Proprietary and Confidential.
Version 7.0 | Page 16
4.
Print out this page and write down the placement of the back modules in the diagram below (back
modules appear on the reverse side when viewed from the front).
Figure 6:
Writing Space for Identifying Back Modules
CAUTION:
Do not mix and match back and front modules. The front module must mate with a back module
of the same product.
5.
Open the front panel and then slide the correct front modules into the slots that match the back
modules.
Note: It may be necessary to rotate the front support post to allow unrestricted access to the
targeted slot. Ensure that the white extractor handle is at the top of the module, facing
outward, as the module is inserted.
6.
Push the module until it seats properly, ensuring the edge of the module is flush with the edge of
the module guides, and the square extractor handle clicks into its slot.
7.
Install the remaining back and front modules, make all of the necessary rear connections, and then
close the front panel.
CAUTION:
To prevent overheating during frame operation, keep the front panel closed and all back module
slots covered.
Removing Selenio Modules from an
MCP3 Frame
Front Module
To remove a front module from a Selenio frame, follow this procedure:
1.
Open the front panel.
2.
Grasp the extractor handle on the module, pulling down slightly.