Image 19.0q Treadmill, Руководство пользователя

Страница: 23 / 34

23
THE INFORMATION MODE/DEMO MODE
The console features an information mode that keeps
track of total number of miles that the walking belt has
moved and the total number of hours that the treadmill
has been used. The information mode also allows you
to switch the console from miles to kilometers. In addi-
tion, the information mode allows you to turn on and
turn off the demo mode.
To select the information mode, hold down the Stop
button while inserting the key into the console. When
the information mode is selected, the following informa-
tion will be shown:
An “E” for English miles or
an “M” for metric kilometers
will appear in the Speed dis-
play. Press the Speed in-
crease button to change the
unit of measurement.
The Distance/Incline display
will show the total number of
miles (or kilometers) that the
walking belt has moved.
The Time/Pace display will
show the total number of
hours that the treadmill has
been used.
IMPORTANT: The Calories/Pulse display should be
blank.
If a “d” appears in the display, the console is in
the “demo” mode. This mode is intended to be used
only when a treadmill is displayed in a store. When the
console is in the demo mode, the power cord can be
plugged in, the key can be removed from the console,
and the displays and indicators on the console will au-
tomatically light in a preset sequence, although the
buttons on the console will not operate.
If a “d” appears
in the Calories/Pulse display when the information
mode is selected, press the Speed decrease button
so the display is blank.
To exit the information mode, remove the key from the
c o n s o l e .
THE OPTIONAL CHEST PULSE SENSOR
An optional chest pulse sensor adds even more
features to the console. The chest pulse sensor provides
hands-free operation and allows the console’s heart
rate programs to be used.
To purchase the optional
chest pulse sensor, call toll-free 1-800-753-4645.
If you purchase the optional chest pulse sensor,
follow the steps below to install the receiver and
the short jumper wire included with the chest
pulse sensor.
1 . Make sure that the power cord is unplugged.
Remove the indicated 3/4” Screw (6) and the Access
Door (94) from the back of the Console Back (95).
2. Connect the wire on the receiver (A) to the indicated
wire extending from the Console Back (95).
Remove the paper from the adhesive pad on the
back of the receiver.
Hold the receiver so the
small cylinder is near the lower edge of the re-
ceiver and is facing the Console Back as shown.
Firmly press the receiver onto the indicated corner
of the Access Door (94). Note: If there are two
screws included with the chest pulse sensor and
two plastic posts on the inside of the Access Door,
attach the receiver to the plastic posts on the
Access Door with the two screws.
3 . Make sure that no wires are pinched. Reattach the
Access Door (94) with the 3/4” Screw (6). The other
wires included with the receiver may be discarded.
A
95
94
Cylinder
6
Wire