13
HOW TO TURN ON THE POWER
Plug in the power cord (see page 11).
Locate the reset/off
circuit breaker near
the power cord. Make
sure that the circuit
breaker is in the reset
position.
Next, stand on the foot rails of the treadmill. Find
the clip attached to the key (see the drawing on
page 12) and slide the clip onto the waistband of
your clothes. Then, insert the key into the console.
After a moment, the display will light.
Important:
In an emergency situation, the key can be
pulled from the console, causing the walking
belt to slow to a stop. Test the clip by carefully
taking a few steps backward; if the key is not
pulled from the console, adjust the position of
the clip.
HOW TO USE THE MANUAL MODE
Insert the key into the console.
See HOW TO TURN ON THE POWER above.
Select the manual mode.
When the
key is in-
serted, the
manual
mode will be
selected. If a
program has
been selected, reselect the manual mode by
pressing the Program Select button repeatedly
until a track appears in the display.
Start the walking belt.
To start the walking belt, press the Start button,
the Speed increase button, or one of the speed
buttons numbered 1 to 10.
If the Start button or the Speed increase button is
pressed, the walking belt will begin to move at 1
mph. As you exercise, change the speed of the
walking belt as desired
by pressing the Speed
increase and decrease
buttons. Each time a
button is pressed, the
speed setting will
change by 0.1 mph; if a button is held down, the
speed setting will change in increments of 0.5
mph. Note: After the buttons are pressed, it may
take a moment for the walking belt to reach the se-
lected speed setting.
If one of the numbered speed buttons is pressed,
the walking belt will gradually change in speed until
it reaches the selected speed setting.
To stop the walking belt, press the Stop button.
The time will begin to flash in the display. To
restart the walking belt, press the Start button, the
Speed increase button, or one of the numbered
speed buttons.
Note: The first time the treadmill is used, observe
the alignment of the walking belt, and center the
walking belt if necessary (see page 23).
Change the incline of the treadmill as desired.
To change the incline of
the treadmill, press the
Incline increase and de-
crease buttons. Each
time a button is pressed,
the incline will change by
0.5%. Note: After the buttons are pressed, it may
take a moment for the treadmill to reach the se-
lected incline setting.
Follow your progress with the display.
When the
manual mode
is selected,
the display
will show a
track that
represents
1/4 mile. As you walk or run, the indicators around
the track will appear in succession until the entire
track appears. The track will then disappear and
the indicators will again begin to appear in succes-
sion.
5
4
3
2
1
3
2
1
Track
Reset
Position
Track
