Page
6
of
8
Guardsman Alarm System
–
Installation Instructions
6.
Additional Wireless Detectors:
**All remote controls and sensors, purchased together have been pre paired
–
please check before re-pairing**
The Hub Alarm System can be used with additional Wireless Detectors, these include:
•
PIR’s.
•
UltraPIR Alarms.
•
Door & Window Contacts.
When these detectors are paired into the same Wireless Network, when any are triggered,
they will automatically trigger the Hub Alarm (which will start to dial key-holders) together
with triggering the Sirens built into any other PIR
’
s
The operating range between the Hub and Wireless Detectors is 100 metres (line of sight)
although this can be much further when multiple units are used as each unit will relay the
signal to the nearest unit.
7.
Full Programming:
There are further optional programming functions that can be used, please see below:
All functions are preceded by pressing the Learn Button
Please Note: 2 Audible Beeps denotes functions being turned ON; 1 Audible Beep denotes
functions being turned OFF.
Operation:
•
#1# (record message) as listed above.
•
#2# (allows you to Arm & Disarm the Alarm using the Built in Keypad).
•
#6# (this controls any audible beep from the Alarm upon activation).
•
#8# (this can turn ON or OFF the Telephone Function, if this is OFF the Alarm would
be able to send SMS (Text) Messages Only.
•
#9# (this can turn ON or OFF the SMS Function, if this is OFF the Alarm would be able
to Call Key-holders Only.
•
#0# (weekly status report ON or OFF) see below:
•
#369# (full reset).
Please allow a few seconds to complete.
