Page
5
of
8
Guardsman Alarm System
–
Installation Instructions
1)
Press * 1 01234567890 * or *1 0044 1234567890* (on some networks).
If you want this phone number to be the third number the Alarm Calls:
1)
Press * 3 01234567890 * or *3 0044 1234567890* (on some networks).
4.
Recording a voice message:
A short (6 second) message can be Recorded into the Alarm, this would be replayed to Key-
holders when the Alarm calls them.
1)
Under disarm mode, activate keypad by pressing the learn button (located to the
right-hand side of the SIM Card).
2)
Press #1# on the Keypad.
3)
Start recording your message (for a maximum of 6 seconds), Speak closely into the
microphone located near the keypad.
The Alarm will automatically reset after 6 seconds.
5.
Programming (pairing) the Remote Control:
**All remote controls and sensors, purchased together have been pre paired
–
please check before re-pairing**
1)
Press and hold the learn button (located on the circuit board to the right-hand side
of the SIM Card Holder.
2)
Press the learn button on the underside of the battery compartment cover of the
remote control.
3)
Wait until you hear 2 beeps.
4)
The Remote Control will now be paired with the Alarm.
5)
Repeat the process (including stage 1) to program further Remote Controls to the
Alarm.
The Remote Control (controls) can be deleted from the
Alarm by holding the learn button inside the Alarm whilst
inserting the last battery, 3 beeps will be heard, this
indicates the Remote Control has been deleted
successfully.
1)
Red LED
2)
SOS Buttons (UltraDial
only)
3)
Lock (ON)
4)
Unlock (OFF)
5)
Learn Button
6)
Battery Compartment
(
Take out screw and Slide
Down
) (CR2032 Battery
replacement)
7)
Battery Cover (
Slide
Down
)
