ILVE Milano, Руководство пользователя

Страница: 5 / 24

5
Positioning Your Appliance
—
REFER TO MANUFACTURERS INSTALLATION
INSTRUCTIONS BEFORE INSTALLING
—
The rating plate is on the right hand side of the door frame
when the oven door is opened. This will give the KW rating
for the Gas Safe engineer to install or check the installation
pipe sizing. The main electricity supply must be installed
by a part P qualified electrician In accordance with the IEE
regulations.
—
The cooker may be installed in a kitchen or open-plan living
space but not in a room with a bath or shower.
—
The cooker should be positioned in area away from
draughts.
—
Important Note: ILVE cooker hoods can only be fitted
with either 150mm rigid plastic ducting or Aluminium flexi
ducting. Plastic flexi ducting must not be used under any
circumstance.
—
Any shelf, over mantle or cupboard should be 700 mm above
the hob top. Cooker hoods should be set at a minimum of
650mm above the hob. Also, there should be a gap of 50mm
wide on either side of the cooker on or above counter level.
Behind the hob top and to the sides of the hob should be
clear of any combustible material to a height of 400mm.
—
Kitchen units must not overhang the hob.
—
Cabinets can be fitted flush to the sides of the cooker but
we recommend leaving a small gap to aid cleaning/moving
the appliance.
Adjusting the Height
The cooker comes complete with 4 adjustable feet found in a
box within the main oven.
Standard Models
—
Legs can be adjusted from 100mm to 160mm to level the
cooker and change the height.
—
Insert screw into the leg of the cooker and tighten by at least
2 full turns.
—
Push the screw head through the hole in the chassis.
—
Slide the leg assemble into the narrow part of the hole and
tighten by turning the leg clockwise.
—
The height of the leg can be increased by unscrewing the
bottom part.
XG Models
—
Feet are screwed into threaded holes in each corner of the
underside of the cooker.
—
The minimum height of an XG cooker is 910mm.