ILVE KHVI60TC, Инструкция по установке и эксплуатации

Страница: 10 / 16

10
Keyboard lock
Selecting the keyboard lock command for one second, acts to either activate or disconnect the keyboard. If the
led that corresponds to the command is lit up, this means that the keyboard is locked. The keyboard lock may
be activated when the four cooking zones are on, or when the hob is off. If the hob is on, the keyboard lock is
engaged, and all the controls will be locked except the ON/OFF command and the keyboard lock command itself.
When the hob is off and the keyboard lock function is enabled, all the controls are disenabled including the ON/
OFF switch.
The keyboard lock is always enabled whilst the hob is being connected to the mains.
Automatic safety cut-off
If during use the power setting of a cooking area is not altered, it turns itself off automatically after a certain
time. The area’s maximum use time depends on the power level setting. See the following table:
Power level Maximum time on (hour)
1 10
2 10
3 10
4 10
5 10
6
10
7 10
8
10
9 3
Use of timer
It is possible to select a cooking time from 1 to 99 minutes on a cooking area with different power levels (from
1 2,,…9, P).
Activate the timer
After having selected the desired power of a cooking area, to activate the timer you need to touch the cooking
area button again: the display shows the letter “t” with a fl ashing dot next to it accompanied by a beep.
After having activated the timer, select the desired time by touching the keys +/-. The set time is displayed on
the display opposite the selected cooking area. After activating the timer, select the desired time within 10 se-
conds. Subsequently, to activate the countdown touch on the cooking area selection or wait 10 seconds. A beep
and the appearance of a lit dot near the previously set power value indicates that the timer is active. During
cooking with timer, the set time can be altered by repeating the above operation.
At the end of the programmed cooking time, on the display relative to the selected hob, “0” starts fl ashing ac-
companied by an acoustic signal lasting 20 seconds. To eliminate the signal, simply press any key.
When the timer is active on several cooking areas, to display the remaining time of a single area, simply touch
twice the command regarding the selection of that cooking area: the corresponding display will show the letter
“t” accompanied, on the opposite display, the remaining time.
Control description