ILVE ILFRZ217/2, Подробное руководство по установке и эксплуатации

Страница: 12 / 28

12
Rev.13052022
IMPORTANT
After completing the installation, check that the appliance is secured within the cabinet unit and that the doors close and open
correctly. If there is no resistance from the door seals when opening the doors, then it is probable that the appliance and all decor
doors are not fitted properly
REVERSING THE APPLIANCE DOOR - TO BE DONE BEFORE FITTING THE PANEL
We recommend you seek the help of another individual to support the doors whilst performing this operation. Always wear
adequate PPE (Personal Protective Equipment) for the task at hand. Prepare a surface with a soft, clean towel or similar where
you can place the door during these steps.
1. Carefully remove the cover cap for the top hinge and unscrew the screws fixing the top hinge to the appliance, you should
support the door whilst doing this.
2. Carefully remove the door from the bottom hinge (by lifting) and place it somewhere safe. Note that there may be spacers
between the door and the hinge; note how many and their position.
3. Swap the previous top hinge to the opposite side at the bottom.
4. Place the door onto the new bottom hinge. Support it.
5. Refit the “new” top hinge and fix securely to the appliance.
6. Fit the central cover caps and top hinge cover pieces in place to complete the process.
7. Unscrew all four slider brackets from the door and swap them over to the side furthest from the new hinge positions, before
the decor door is fitted.
ENSURING THE DOOR SEALS CORRECTLY:
It is normal for the seal to be compressed after the door has been reversed. With the door closed, use a hair dryer to expand
the seal and fill the gap between the door and the body of the appliance.Take care not to use the hair dryer too close to the
appliance, which could damage the seal. A distance of approximately 10cm should be adequate. When completed, allow the
seal and door to cool before touching them. Once done, the seal should remain in position.