7
MATRIX MANUAL 2014
I l l u s i o n - A u s t r a l i a n M a d e G a s L o g F i r e s
DO NOT PLACE ARTICLES ON OR AGAINST
THIS APPLIANCE.
DO NOT USE OR STORE FLAMMABLE
MATERIALS NEAR THIS APPLIANCE.
DO NOT SPRAY AEROSOLS IN THE VICINITY OF
THIS APPLIANCE WHILE IT IS IN OPERATION.
DO NOT MODIFY THIS APPLIANCE.
INSTALLATION
I M P O R T A N T
The installation of any ILLusion Gas Log Appliance
must
be performed only by authorised personnel and in accordance with
the manufacturer’s installation instructions, local gas fitting regulations, municipal building codes, electrical wiring regulations,
AS/NZS 5601 Gas Installations and any other statutory regulations.Please read these instructions carefully before proceeding.
PRIOR TO INSTALLATION
It is highly recommended that the installation of any ILLusion Gas Log appliance is planned on paper before installation begins.
This will ensure correct performance of the unit and eliminate potential problems.
Your ILLusion sales representative can advise on the best position to maximize the performance of the appliance.
In most cases, an
Authorised ILLusion Installer
can be arranged to install the unit, however if this is not possible, a
suitably
qualified person
must be used. These appliances are
not
designed to be installed by the homeowner.
INSTALLERS CHECKLIST
CHECK CLEARANCES TO COMBUSTIBLES
INSTALL HEATER AND FLUE SYSTEM
CONNECT GAS
TEST GAS PRESSURE
FIT GAS LOG KIT
FIT OPTIONAL WALL THERMOSTAT
SAFETY CHECK
CLEARANCE FROM COMBUSTIBLE MATERIALS
:
1.
These appliances must be installed in accordance with the regulations, municipal building codes and
AS/NZS 5601 ‘GAS INSTALLATIONS’
2.
Only an Authorised person should install the appliance.
3.
This appliance should be inspected prior to installation and the dealer contacted if any problems arise.
4.
This appliance must be installed with an approved flue system, which terminates outside the building.
A flue system must never terminate within the roof cavity.
5.
The unit should be checked periodically for lint. The fan area especially is prone to lint build up during
normal operation. Keep the area around the appliance clean and free from lint.
6.
Only persons familiar with the operation of the unit should use the heater.
7.
Do not modify or adjust this appliance. Always contact your ILLusion dealer if any problems arise.
8.
Annual service by an Authorised service person will ensure trouble free operation for many years.
9.
This Gas heater is not designed to burn solid fuels.
NEVER
use paper, wood or any other fuel in this
appliance.
10.
Keep the immediate area around the heater free from any combustible materials: i.e.: aerosols, or other
flammables.
11.
If you smell gas whilst the unit is operating, immediately shut down the unit and turn the gas off at the
supply shut off valve, or the main meter. Contact Illusion or your local gasfitter.
DO NOT ATTEMPT ANY REPAIRS ON THE HEATER YOURSELF. ONLY AN AUTHORISED PERSON MAY REPAIR OR
ADJUST THE HEATER ACCORDING TO THE MANUFACTURERS INSTRUCTIONS.
PAINT CURING
SOME EXTERIOR SURFACES OF YOUR ILLUSION GAS APPLIANCE HAVE BEEN FINISHED WITH THE
HIGHEST QUALITY HEAT RESISTANT PAINT. PLEASE NOTE THAT THE INITIAL FIRING OF THE UNIT MAY
PRODUCE SOME SMOKE AND ODOUR AS THE PAINT CURES.
TO ENABLE CURING, THE UNIT MUST BE
RUN ON HIGH WITHOUT THE FAN ON FOR APPROX. 3 - 4 HOURS. IT IS ADVISABLE TO KEEP WINDOWS
AND DOORS OPEN DURING THIS PERIOD IF POSSIBLE.
SAFETY INFORMATION
