ilco 79M Series, Руководство по установке

Страница: 29 / 38

PK3561_10_09 • 79 SERIES INSTALLATION GUIDE
28
APPENDIX A.2 • Additional steps for Autodeadbolt ASM for 79M
Standard mode only
Do the following INSTEAD OF page 10, step 5:
A. 2.1 79M Standard mode inside trim assembly for ASM. See
E on page 4
A. 2.2 79T Toggle mode inside trim assembly, for cylindrical;
autodeadbolt and ASM. See page 6
A. 2.3 79M Standard mode autodeadbolt inside trim assembly.
If not already installed at the factory, put the thumbturn in the
vertical position and install all four parts (M) as shown on the
inside trim assembly.
Install clip M1
diagonally on hub
The thumbturn has to be in the vertical position as shown in
Fig. A.2.3. For Right Hand installation, the arrow of M2 points
UP. For a Left Hand installation the arrow of stopper M2 points
down.
Place 3 spacers (S) on the door (for recent models only). For
79T Toggle mode, connect switch cable (W2) to outside hous-
ing cable(W1). Place the inside trim assembly with thumbturn
"T" in position shown below, on the door so that the upper
and lower spindles (F) and (G) engage the thumbturn and the
inside lever. For 79T Toggle mode, push the 2 connectors &
the maximum of their cable in hole (H1).Fasten to the outside
housing using the three 1/8" hex head mounting screws (I).
Apply the privacy thumbturn sticker as shown. If in doubt as
to the direction of the arrow, press the auxiliary latch (X) to
extend the deadbolt, and verify in which direction to rotate the
thumbturn to reach the horizontal (privacy) position.
RH/LHR LH/RHR
X
W1
W2
E or E2
H1
Fig. A.2.3