TM60Pi (06/00)
PAG. 10
4.- USE
To ensure correct use of the equipment, follow the instructions below:
!
Make sure the transmitter you are going to use is the right one, identifying the machine
on the identification label.
!
Attach the belt to the transmitter unit. Its use is recommended to prevent the
equipment from falling.
!
Introduce a charged battery, turn the contact key. This will activate the transmitter.
!
To activate the system, you must first pull out the STOP button, the green LED should
then give a green pulse; then press the START button. If you find that the STOP
button has already been pulled out, it is necessary to push it in and then pull it out
again, as this sequence will allow the check in of the STOP circuit. If the unit has
experienced a time-out auto-disconnection, it is not necessary to repeat the STOP
button procedure, simply push the START button for 1 second.
!
The green LED should light up, indicating that the transmitter has started transmitting.
From now on, if any of the transmitter’s command buttons are pressed, the
corresponding manoeuvre will be activated.
!
To be able to start up the transmitter, all the command controls associated with active
manoeuvres must be in the neutral position (not activated). This is not the case for the
selection functions.
!
When 4 minutes have passed and no active manoeuvre command has been activated,
the transmitter automatically switches off. To start it up once more, press the start
button.
!
The transmitter is equipped with a circuit for monitoring the battery level. When this
level drops below a pre-established limit, the transmitter LED starts to flash in red, and
a buzzer goes on; 5 minutes later the transmitter switches off, and the machine’s main
contactor is deactivated. During this time, the load has to be located on a safe
position.
!
The console transmitters have tilt monitoring circuit to detect abnormal console
positions. The transmitter cannot work if it is not in the vertical position. If the console
is not in a vertical position, the LED will flash red three times and a buzzer will go off. If
the console is tilted while transmitting, after 2 seconds all manoeuvres will cease even
if the main contactor is still on. To reinitiate transmission, the console must be put back
in the upright position and the manoeuvres must be deactivated.
!
To switch off the transmitter, press the STOP button or turn off the contact key.
Remember that you are going to remote control a moving piece of
machinery. The safety instructions described in chapter 2 of this
manual must be strictly adhered to.
