OP-131Tx_V2 User Manual.docx
Page
15
of
19
30-Aug-2018
© 2018 IKUSI ANZ Pty Ltd - All rights reserved - Reproduction without consent is prohibited
ethcfg
This command configures the Ethernet parameters, including IP address, subnet mask and
gateway. You can refer to the help information for its using.
settrap
This command shows or modifies the aim host IP address list of the SNMP Trap,
IP address of 0.0.0.0 and 255.255.255.255 don’t exist. SNMP Trap does not send to these two
addresses.
community
This command configures the read-only group name and read-write group name. “Group
name” is the concept of SNMP agreement like the password. Use the command “community
ro” to configure the read-only, and “community rw” for the read-write. For example, input
“community rw public”, “public” is the read-write group name. The group name for read-
only and read-write are both “public” as the equipment default setting from factory.
setpswd
This command is used to modify login password.
entplogo
This command is used to set company logo and equipment model.
Exit
This command is used to logout.
