IKTCH IKB01 Series, Руководство по установке и Руководство пользователя

Страница: 8 / 12

Final Assembly
1.Install the oil tunnel into recess support near rear of hood, and assemble the
handle to stainless steel baffle filters Refer to Figure 7.
2.Install baffle filters. Angle baffle filter toward back of hood 1 . Push baffle filter
up until almost level 2. Slide forward into recess behind the front of hood 3.
Lower baffle filter 4. Slide back until it fits into resting position 5. Refer to Figure 7.
7
IKB01
/
IKB02 SERIES
1
.
From left to right side: Lighting Key (K1), Timer Key (K2), LED Display, Speed
Key (K3), Power Key (K4)
2
.
When the power supply connected, all indicate lighting is On and then Off in 1
second. To press K4 to open the hood.
st
3
.
When the hood is On, to press K3 to open Fan Speed 1 , to press again to
nd rd th
open Fan Speed 2 , as so forth, to open Fan Speed 3 and 4 by K3. The Fan
Speed is changed as 1-2-3-4-0-1-2-3-4.
4
.
If there was any fan speed working, to press K2 to open Timer Mode, the
default is 3 minutes and do count-down step. Or to press K2 or K3 to set the
timer as wanted, the maximum timer is 15 minutes.
5
.
To press K1 to open or close the lamp. The luminance of lighting can be
adjusted from 0% to 100% as wanted by touching K1.
st
6
.
Gesture Control : to move your hand from left side to right side to open 1 Fan
nd rd th
Speed. And again to open 2 Fan Speed, and 3 , and 4 .
On the contrary, to move your hand from right side to left to reduce the speed
level.
Please Note: when using gesture control function, please make sure to move your
hand from 2 signal ports completely.
Optional
This hood switch control can be operated by remote controller if wanted.
·
13
· ·
14
·