IKTCH IKB01 Series, Руководство по установке и Руководство пользователя

Страница: 7 / 12

Hood Installation
NOTE: USE HAND TOOLS ONLY. DO NOT OVER TIGHTEN SCREWS. IT MIGHT
CAUSED DAMAGED TO THE HOOD.
1.Remove 5 screws located at the bottom of the insert (Refer to Figure 2 and
figture 3).
2 3
2.Disconnect the 2pcs LED lights wire and switch wire, then carefully remove
the light support panel from hood body refer to figture 4
4
3.Position the insert inside the custom wood frame, refer to figture 5, Secure the
insert to the left and right stud support ( Refer to Figure 5) by using the left and
right mounting holes (Screws included, 2 holes each side ).
5
4.Make sure insert is secure before releasing.
5.Re-install the light support panel. (Do not over tighten screws.) Refer to figture 6
6
·
11
· ·
12
·