Port Removal
Port Installation
1. Facing the front of the housing,
place a Strap Wrench over the
housing port.
2. Tighen Strap so that the Handle is
as close to the port as possible.
3. Rotate the Handle counter-clockwise
to loosen and remove the port,
Diagram A.
4. Place the port and port o-ring in a
resealable plastic bag for storage.
1. Facing the front of the housing, attach the Wide Angle Port to the
housing by rotating port clockwise into the port hole opening until snug.
2. Place a Strap Wrench over the housing port.
3. Tighten Strap so the Handle is as close to the port as possible.
4. Rotate the Handle clockwise to tighten port, Diagram B. Tighten until a
good o-ring seal (dark circular line) can be seen from inside the housing,
Diagram C.
Diagram A
Diagram B
4
Diagram C
Handle
Handle
Strap
Strap
O-ring Seal
(view from rear of
housing with back removed)
Port
Port
Port
