14
STEP 7 - Attach Optional Mirrorless Lens Port
STEP 8 - Final Check
CAUTION: This housing does NOT come with a lens port. An
optional Mirrorless Lens Port must be properly attached to the
housing before submersion in water; see ikelite.com for compatible
lens/port combinations. After purchasing an optional port for your
lens, reference your port instruction manual for proper installation
procedure.
Once the Port is properly installed you can test the housing for
watertightness without a camera inside to ensure all housing seals are
working properly.
The clear housing permits instant visual inspection of the camera
and sealing surfaces as well as complete monitoring of controls and
camera LCD screens. This housing has been factory water pressure
tested to 200 ft (60m).
Once the housing is closed, recheck the o-ring seal. Double check the
gap between the housing back and the housing. It should be even all
the way around the housing.
Look through the clear plastic back at the o-ring. You should see a
darkened area or solid black line where the o-ring is compressed
against the housing back. If you do not see an even black
compression seal all the way around the back, open the lid snaps,
reseat the housing back and close the lid snaps. Visually check the
seal again.
USAGE
Turn the camera on and operate each of the housing controls to get a
feel for using the camera in the housing.
