11
STEP 6 - Closing the Housing
1. Place housing face down in your
lap or on a flat surface. Check to
see that there is an o-ring on the
housing back, and that it is clean
and in its proper location.
2. Guide the back onto the housing
front. Make sure the hotshoe wire
is out of the way. Once the back
is properly installed, the o-ring
should touch the housing all the
way around. There should be an even gap on each side of the housing
between the housing and the back.
3. Lift the lid snaps so they are extended and place each lid snap into the
corresponding hook on the housing back.
4. To close the housing, push down on the opposing lid snaps
simultaneously until they snap into place. Be sure they are down far
enough to engage the
lock
-
Page 9
. The o-ring seal should now appear
as a solid black line from the back of the housing.
Housing Back
O-ring
Even gap on
all four sides
Lid Hook
Lid
Snap
STEP 5 - Attach the Hotshoe
Slide Hotshoe into the top
camera mount until it stops.
Hotshoe must be all the way
forward in the camera mount
to assure a good electrical
connection with a strobe.
Make sure hotshoe cord does
not interfere with the back
when closing housing.
Hotshoe
