3
Attaching the Control Ring Gear
(see illustration below)
The supplied Control Ring Gear is attached to the camera control ring by
3 small nylon allen Set Screws. Place the Control Ring Gear over the
camera’s control ring
before installing the
camera in the
housing. The gear is
a “press fit” over the
lens and goes on
one way with the
allen screws
closer
to the camera body
than the end of the
lens. Gently tighten
all three allen screws
with the supplied
Allen Wrench as show in the Diagram.
Do not
overtighten or you will
damage the gear. Make sure to test it’s function once installed.
Canon
S120
The camera does NOT operate with TTL “automated” flash when in the
“M” manual mode. “M” manual mode should NOT be used with the AF35
strobe.
Camera functions can be assigned to the Control Ring by pressing the
Ring Function button. Depress the Ring Function button until the
desired function is highlighted in the camera LCD screen. Once the
function is highlighted, it can be adjusted using the Control Ring.
Refer to your camera owner’s manual for additional information.
To use the camera in Manual mode, rotate the Mode Dial to “Tv” and set
the shutter speed. Then, rotate the Mode Dial to “M” Manual Mode.
Press the Ring Function repeatedly until it is set to “STD.” Then, use the
Control Ring to adjust Aperture setting as needed.
Control Ring Gear
(properly installed)
Setup Notes
(continued)
