Initial Camera Setup
(before placing camera in housing)
- Set camera mode switch to “Av” Aperture Priority.
-
In MENU:
Set AF Frame to “1-point” and AF Frame Size to “Normal.”
Set Digital Zoom to “Off” and AF-Point Zoom to “Off.”
Set Servo AF to “On” and Continuous AF to “On.”
Set Touch Shutter to “Off” and AF-assist Beam to “Off.”
In the
Flash Settings
menu, set the Flash Mode to “Auto.”
Set Shutter Sync to “1st-curtain.”
Set Red-Eye Correction and Red-Eye Lamp to “Off.”
Set Safety FE to “On.”
Set Spot AE Point to “AF Point” and Safety Shift to “On.”
In Review image after shooting, set Display Time to “4 seconds.”
Set Blink Detection to “On” and IS Mode to “Continuous.”
Set Control Ring Func. to “STD” Default Control Av.
-
In FUNC./SET:
Set ISO to “200” and White Balance to “AWB.” For best results, use
Manual White Balance and reset for each working depth.
Set Shooting Mode to “Single Shot .”
Set Metering to “Center Weighted Avg .
Set ND Filter to “ND Off”, and Still Image Aspect Ratio to “4:3.”
Set Image Type to “JPEG”, Image Size to “L” and quality to “Superfine.”
Set Movies to “FHD/60P”, Shadow Correct to “Auto.”
Set DR Correction to “Off”
-
RAISE FLASH
and set to forced ON (flash always fires) “ .” Flash
CANNOT be raised once camera is closed in housing.
Setup Notes:
If shadows are present, use two external strobes. Also, you can set
Shadow Correct to “Auto”, which will help to lighten shadowed areas.
Set Macro Mode to “On” when shooting very close subjects.
Continued on Page 3.
2
1
