4
This product has been water pressure tested at the factory and is depth
rated to 200 ft. (60m). Thoroughly inspect and immerse the empty
housing completely in water before installing a camera. If any fogging
occurs or droplets of water enter the housing, do not install a camera.
Clean the housing main o-ring and retest to make sure that it is
watertight. Refer to the Troubleshooting section, page 17.
Please read your camera manual thoroughly to have a full understanding
of each camera function.
If you are new to underwater photography, be sure to read the Photo
Tips section, page 16.
Preparation
Initial Camera Settings
(before placing camera in housing)
-
Insert and Format an SD memory card.
-
Set Date and Time.
-
Set REC Mode to “P” Program Auto. Set REC Mode to “M” Manual
mode to manually adjust aperture and shutter speed settings.
-
Set Still Image Size to “18M.”
-
Set ISO to “100.”
-
Set White Balance to “WB Auto.”
-
Set Focus to “Center AF.”
-
Set Metering Mode to “Center.”
-
Set Flash to “On always use flash.”
-
Set AF Illuminator to “Off.”
-
Set Red-Eye Reduction to “Off.”
NOTE:
If overexposure occurs, use “-” exposure compensation, back away
from your subject and zoom in, or switch to “M” Manual mode, and
adjust aperture and shutter speed settings. When using an AF35 strobe
or manual controller, turn the power down.
