Preparation and Installation
5
1. Install a fully charged Canon BP 820 or BP 828 battery.
Caution:
Other
brand batteries are not recommended as they may interfere with the
camera mounting or housing seal.
2. Remove the camera lens cap, lens hood and cord to eliminate any
interference with the housing seal.
3. Attach Camera to Housing Tray -
Diagram A, Page 3
:
- Position the camera against the Tray Stabilizing Pins. The camera
should be parallel with the sides of the tray and should fit easily on the
tray.
- Tighten the Mounting Bolt into the camera base with a screwdriver
(preferred) or a coin so the camera is tight against the tray.
4. Initial Camera Settings for Underwater:
- Set Power Switch to “CAMERA.”
- Set Zoom Rocker to “Wide Angle” setting.
- Set Mode Switch to “Auto.”
5. Inserting the Camera:
- Check that the housing o-ring is clean and properly positioned on the
lip of the clear back plate.
- With the camera properly mounted to the tray, pull out the housing
controls to provide clearance for the camera.
- Align the back plate with the clear housing and slowly place the back
plate against the housing. DO NOT force this installation. If the camera
is aligned properly, it will fit easily inside the housing. The back plate
should be flat against the housing and NOT tilted on one side.
6. Slide the housing controls back in place making sure they properly align
with corresponding camera functions.
7. Close Lid Snaps simultaneously. Make sure the Snaps are down far
enough to engage the locks. Refer to
Page 3
of the General Instruction
Manual.
