Ikegami ISD-A15S, Инструкция по эксплуатации

Страница: 9 / 46

E-4
①
Lens mount (CS mount)
This is used to mount the lens on the camera. Many types of CS mount
lens can be attached.
②
Back focus lock screw
After completing the flange back adjustment of the camera, use the
supplied Allen wrench to tighten the screw until it is fully fixed.
③
Holder mounting screw holes
These holes are used to install and fix the camera on the camera
mounting or bracket. They can be also applicable to general use tripods
which have a quarter inch thread.
Note
To use these holes to attach the camera on a tripod or other
mount, make sure you use suitable size mounting bolts as follows
(1/4” -20UNC), they should not be longer than 5.5 mm to avoid
an un-stable installation.
④
Auto iris lens connector
Specifically used to connect the auto iris lens.
Applicable connector: E4-191J-100 or equivalent
●
DC Iris System
— Connector cable leads —
1. Damping coil (-)
2. Damping coil (+)
3. Driving coil (+)
4. Driving coil (-)
* Connect the leads as shown above.
Please refer also to the instructions of the lens to be used.
3
2
1
4
Connector pin assignment
3
2
1
4
Auto iris lens