IKEA ENHET, Руководство по установке

Страница: 14 / 20

14
Installing the plinth
NOTE! If you’re not installing plinths, please move on
to next chapter.
Generally, the base cabinets are fixed to wall and
supported by legs in the front of the cabinets.
However, if you are going for a kitchen with a plinth,
you also need to consider the following steps:
For a plinth setup, place the legs with the leg-plate
aligned to the cabinet edge. Since the plinth is attached
via the legs, you also need an additional leg at the back
of the cabinet sides.
22 1/8” (562 mm)
Start with the plinth for the short side of the cabinet
and use a handsaw to cut a 22⅛” (562 mm) piece. Then,
sand the open edge before you apply the pre-glued
edge band that comes with the plinth.
Follow the assembly instructions to attach the plinth.
Remember to remove the plastic sleeves of the leg since
they will obstruct the attachment of the plinth.
For the front plinth, place the plinth in position and
mark where to cut it. After you’ve cut it, repeat the
process of attaching the edge band and the plastic
fittings that connect with the leg.
When two plinth sections meet and form a corner, you
need to attach both plinth strips to the same leg. In
order to avoid the clips colliding, place the clips upside
down in one of the strips.
NOTE! ENHET open frames can’t be combined with a
plinth. For ENHET frames, use ENHET legs for frames.