IKEA ELDSLAGA, Руководство пользователя, Страница: 15 / 40

ENGLISH 15
- Nozzles not supplied with the appliance
must be ordered from After Sales
Service.
- Adjust the minimum setting of the taps.
NOTE : when liquid petroleum gas is used
(G30/G31), the minimum gas setting screw
must be tightened as far as it will go.
IMPORTANT : should you experience
difficulty in turning the burners knobs,
please contact the After Sales Service for
the replacement of the burner tap if found to
be faulty.
Replacing the injectors (see paragraph
“injector table”)
- Remove grids ( A ).
- Extract burners ( B ).
- Using a socket spanner of the
appropriate size unscrew the injector
( C ), unscrew the injector to be replaced.
- Replace it with the injector suitable for
the new type of gas.
- Re-assemble the injector in ( D ).
Before installing the hob, remember to affix
the gas calibration plate supplied with
the injectors in such a way that it covers
the existing information relating to gas
calibration.
D
C
A
B
Adjusting minimum gas setting of taps
E
To ensure that the minimum setting is
correctly adjusted, remove the knob ( E ) and
proceed as follows:
- tighten screw to reduce the flame height
( - );
- loosen screw to increase the flame
height (+).
The adjustment must be performed with the
tap in minimum gas setting position (small
flame).
- The primary air of the burners does not
need to be adjusted.
- At this stage, light up the burners and
turn the knobs from max position
to minimum position to check flame
stability.
Upon completion of adjustment, reseal
the work surface using sealing wax or an
equivalent material.
REFERENCE TO LOCAL REGULATIONS
Ensure that the installation and gas
connections are performed by a qualified
technician, following the manufacturer’s
instructions and in compliance with current
local safety regulations.