180˚
3. Turn the filter 180
degrees in anti-
clockwise direction to
open it, without
removing. Let the
water flow out.
4. When the bowl is
full of water, turn the
filter back and empty
the container.
5. Repeat the steps 3
and 4 until the water
stops to flow out.
1
2
6. Turn the filter anti-
clockwise to remove
it.
7. If it is necessary,
remove fluff and
objects from the filter
recess.
Make sure that the
impeller of the pump
can rotate. If it does
not rotate, contact the
Authorised Service
Centre.
8. Clean the filter
under the water tap.
2
1
9. Put the filter back
into the special guides
by turning it
clockwise. Make sure
that you tighten the
filter correctly to
prevent leakages.
1
2
10. Close the pump
cover.
When you drain the water with the
emergency drain procedure, you must
activate the drain system again:
1. Put 2 litres of water in the main wash
compartment of the detergent dispenser
drawer.
2. Start the programme to drain the water.
Cleaning the inlet filter and the filter
valve
If the appliance takes long to fill with water
or doesn't fill, the starting button indicator
flashes in red. Check if the water inlet filter
and the valve filter are blocked (see chapter
"Troubleshooting" for more details).
Proceed as follows:
• Turn off the water
tap.
• Unscrew the hose
from the tap.
• Clean the filter in
the hose with a
stiff brush.
• Screw firmly the
inlet hose back
onto the tap.
ENGLISH
38
